EXTERNAL USE
13
Power up the EVB board
Powers the S32K144EVB evaluation board from a
USB. By default, the USB power is enabled by
J107 jumper (2-3 closed).
Connect the USB cable to a PC and connect micro
USB connector of the USB cable to micro-B port J7
on the S32K144EVB.
Allow the PC to automatically configure the USB
drivers if needed.
When EVB is powered from USB, LEDs D2 and D3
should light green.
The EVB board is preloaded with a software
toggling the RGB LED colours periodically between
RED-GREEN-BLUE.
To Next Page
Loading...
