10
S32K148-T-BOX RDB
Out-of-the-Box Setup
POWER UP THE BOARD AND
DEBUGGER CONNECTION
The S32K148 T-BOX RDB powers from
external +12V power supply via the
23-pin ECU connector with the wiring
harness. If no 23-pin ECU connector
wiring harness available, the board be
powered by J31-8 (GND) and J31-1
(+12V)
Note: There is no embedded debugger
(e.g. OpenSDA) on the RDB, so debug
is done using PEMicro U-Multilink/FX
through J12 with a mini-20 pin cable on
debugger’s port F
After power on, the D10, D11 and D12
on the left up corner of the board will
light on
With Connecting the U-Multilink
debugger to PC, its USB and TGTPWR
LED will be lighted on
USB Cable to PC
DC - 12 V
power supply
S32K148 T-BOX RDB SETUP CONNECTION
To Next Page
Loading...
