NXP Semiconductors S32K3X4EVB-Q172 - Default Jumpers

NXP Semiconductors
S32K3X4EVB-Q172 HWUM
S32K3X4EVB-Q172 | S32K3X4EVB-S172 - Hardware User Manual
S32K344EVB-Q172 | -S172 HWUM
All Information provided in this document is subject to legal disclaimers
© NXP B.V. 2020. All rights reserved
NXP Semiconductors
REV A – 10/2021
Page 29 of 31
14 S32K3X4EVB-Q172 | -S172 - Default Jumpers
Figure 30. S32K3X4EVB-Q172 | -S172 – Default jumpers’ configuration
Table 19. Default Jumper Configuration
Interface
Reference
Position
Description / Comments
FS26x
SBC
Power
Supply
J22
1-2
FS26_VLDO1 [+5.0V] is routed to P5V0 domain
J26
1-2
FS26_VLDO2 [+3.3V] is routed to P3V3 domain
J1
1-2
Flash Mode – configuration in the FS26
J5
1-2
S32K344 MCU
Power Supply
J18
1-2
P5V0 (+5.0V from the FS26) is selected for the VDD_HV_A_MCU reference.
J10
1-2
VDD_HV_A is routed to VDD_HV_A_MCU reference. A jumper on this position disables the shunt
resistors R57 and R58 are disabled for current measurement proposals.
J19
3-4
P3V3 (+3.3V from the FS26) is selected for the VDD_HV_B_MCU reference.
J15
1-2
VDD_HV_B is routed to VDD_HV_B_MCU reference. A jumper on this position disables the shunt
resistors R74 and R75 are disabled for current measurement proposals.
J9
1-2
VDD_HV_B is routed to VDD_HV_B_PERH
J8
1-2
VDD_HV_A is routed to VDD_HV_A_PERH
J31
5-6
The VCORE reference from the FS26 is selected to supply the V15_MCU domain.