NXP Semiconductors TDA11106 Series - Page 12

12
CVBS OUT 0~1 VIDEO output setting 0:IF,1:CVBS 1
CH-MUTE CNT 2~15 No signal change channel mute time Setting 5
WEAK SIGNAL 0~1 WEAK signal Setting 0
B.BACK 0~2 Background selection 0:no,1:blue,2:black 0
BLANK MUTE 0~1 Change the TV channel MUTE selection 1
AV CNT 0~15 Change the AV channel MUTE selection 2
PLUG&PLAY 0~1 Power on auto search selection 1
STB CNT 0~255 Off delay time 0
CHG MUTE PIN 0~1 Change the TV channel MUTE time Setting 1
RESET TIME 0~15 Reset time selection 2
V.GUARD 0~15 V.GUARD function selection 0
N3 OPT 0~1 N3 selection 1
P13
XDT 0~1 x-ray detection on/off 0
P.OFF.SET 0~1 Power off setting 0
SCR BLN 0~1 SCR BLN setting 0
CBS 0~1 Control sequence of beam current limiting
0:normal operation(contrast—brightness)
1:control on contrast and brightness in parallel
0
MUS 0~1 Colour decode matrix setting 0: Japan1:USA 1
MTXF 0~1 Colour matrix selection 0: standard 1: force 0
FCO 0~1 Forced Color-on 0:on 1:off 0
CB 0~1 Chroma bandpass center frequency 0
BPB2 0~1 Bypass sound bandpass filter section 2
0:bandpass filter active 1:bandpass filter
bypassed
1
GROUP DL 0~1 Group delay on CVBSI signal 0:no group delay
correction 1: group delay correction switched on
1
DSG 0~1 Extra gain selection loudspeaker outputs 0:+0
dB 1:+6 dB
0
P14
COLD RD- 0~31 Cool color temperature adjusting of red 10
COLD BD+ 0~31 Cool color temperature adjusting of green 10
YUV R.B -32~+32 YUV R OUT Amplitude Adjustment 0
YUV G.B -32~+32 YUV G OUT Amplitude Adjustment 0
YUV B.B -32~+32 YUV B OUT Amplitude Adjustment 0
YUV H.PHASE -32~+32 YUV Horizontal shift adjusting 0
WARM RD+ 0~31 Warm color temperature adjusting of red 10
WARM BD- 0~31 Warm color temperature adjusting of green 10
PP1
BRI.STD 0~100 Standard Brightness in pp mode 50
CON.STD 0~100 Standard Contrast in pp mode 50
COL.STD 0~100 Standard Color in pp mode 50