NXP Semiconductors
UM11483
Getting Started with NXP Wireless Modules for i.MX 8M-Quad Platforms
UM11483 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2020. All rights reserved.
User manual Rev. 1 — 28 September 2020
18 / 39
• Install 0Ω 0402 resistors: R1429, R1430, R1431, R1432, R1433, R1434, R1435 and
R1436 (M.2 J1401)
Figure 11. M.2 J1401 registers
Note: The hardware rework instructions enable the SDIO support from SD card
connector to M.2 connector. The software change also required to make it fully functional
the feature. Please refer the section 5.6.3 to enable the SDIO on M.2 using DTB file.
Please note that the SDIO on MicroSD card slot functioning will be disabled after the
rework and vice-versa.
To Next Page
Loading...
