NRJ – Assembly and settings manual
Thank you for the purchase of our glider, we hope that you will enjoy flying it!
Please pay close attention to the following assembly instructions, to have the most reliable machine
the NRJ can be.
Servo tray preparation.
The servo tray is 3D printed and requires some fine-tuning to sit perfectly in place in the fuselage. Small thickness
variations in the fuselage are expected, and as such it is necessary to lightly sand the tray for a perfect mating. The tray
should maintain accurate dimensions in the corners and along the length of its contact with the fuselage. It should also
let servo wires through freely. Run multiple dry fittings and check that the external nose cone slides without forcing or
deformation. An improper placement of the tray may prevent the nose cone from fitting when the servos and servo
horns are mounted.
To Next Page
Need help?
General