(5) Moving & fixing the base unit
Place a level on the saw table and djusting foot stands,
so the saw table is level from left to right and from front to
back. Lock the foot studs in position by tightening their
jam bolts against the machine body. (fig.5)
*Remind firstly to remove the wood ad supporting of motor
before starting the table saw.
(6) Extension Tables content
How to install the extension tables
1. Thread the set screws into the suitable holes from the
inside of both extension tables.
2. Before the tables are leveleed, please don't completely tighten
the bolts in follw steps.
3. Attach the large extension table with three cap screws, lock
washers and flat washers (Fig. 6)
To Next Page
Loading...