OBERON Arc Flash Suit User Manual

Oberon Company ▪ 800-322-3348 ▪ service@oberoncompany.com ▪ www.oberoncompany.com
6
no oded nwards and are yn a over op o e
coat. Do not tuck the hood inside of the collar.
• Double check all closures, sealing any gaps and
nspecn or correcness o . Reac yor and
around to the back of the hood and switch the fan
bac o O beore proceedn o se yor arc as
suit.
HOW TO TAKE OFF (DOFFING)
HOOD
• Remove hood, turn fan switch to “OFF”.
• Retrieve the suit storage bag; remove the can of Dis-
infectant spray and soft cloth.
• Holding the can 18” away from the hood surface,
lightly spray the inside of the hood with the Disinfec-
tant being careful to never spray the outside of any
par o e arc as s or over sprayn crean
pooling on the inside of the hood window.
• Always avoid spraying the inside of the hood window.
• mmedaey wpe accdena spray o e nsde o
the hood window using soft cloth.
• Place the can of Disinfectant spray and soft cloth
back inside of the storage bag.
• Place the hood down on a clean surface with the hood
opening facing up, allowing the inside of the hood to
completely dry before storing.
COAT
• Remove your coat and fold lengthwise before placing
back inside of the storage bag.
• Proceed to removing the bib-overalls by opening the
cinch straps on the sides and at the ankles, then pull-
ing the suspender straps over your shoulders.
BIB-OVERALLS
• Find a bare space on a wall or by sitting on a chair,
balance your weight and pull your legs through the
bib-overalls. It is helpful to use your opposite hand to
hold the bottom of the bib-overall pant legs allowing
your work boot to easily pull through. Remember to
pon yor oes down.  yor wor boos are e-
cessively soiled remove them before removing the
bib-overalls.
• Once the bib-overalls are removed fold them length-
wise and place them on top of the coat inside of the
suit storage bag.
STORAGE
• c p e ood sn e ower ap rom e ron
fold up and over the outside of the hood window to
prevent shield damage while being stored.
• Fold the back of the hood including the fan unit inside
of the hard hat and place the hood into the storage
bag.
• Zip closed the storage bag and store in a safe dry
location.
Oberon User Guide
Arc Flash Suit Storage, Use, Care, & Maintenance
FINAL INSTRUCTIONS ON STORAGE
• Use a storage bag or storage locker in a clean dry
environment. Never store with sharp objects, or in
dusty areas.
• To avoid color fading and loss of strength never store
nder drec sn or oer   sorces ra-
daon does no aec ea and ame proecon
• ron ap o e ood sod be sed o proec e
window inside of the storage bag; otherwise hood
• storage bags are available.
- When placing the hood inside of a storage bag
p p e ron ap o cover e ood sed
window.
• Recommend odn e arc as s coa bb-overa
or coverall before placing in storage.
•
•
e sre a powered componens are rned o beore
storage including the fan unit and LED lamp.
To ensure the hood ventilation system fan does not
turn on while using a storage bag, disconnect the fan
unit from the coupling (turn fan counter clockwise),
open battery storage compartment cover and remove
one battery. Replace the battery compartment cover
and store in a pouch inside of the overall storage bag.

OBERON Arc Flash Suit Specifications

General

Brand	OBERON
Model	Arc Flash Suit
Category	Welding Accessories
Language	English