3
Operating Instructions and Parts Manual 24878
5/18
2018 OEMTOOLS
™
PORTABLE MECHANIC’S
FAN - 1200 CFM
10. If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or qualified persons
to avoid injury.
11. DO NOT run the cord under carpeting.
12. DO NOT cover the cord with throw rugs, runners or
similar coverings.
13. DO NOT run the cord under furniture or appliances.
Make sure the cord is away from cluttered areas and
where it will not be tripped over.
14. DO NOT use if electrical cord is frayed or bent.
CAUTION
15. DO NOT immerse the Fan in water.
16. This Fan is not intended for use by people (including
children) with reduced physical, sensory or mental
capabilities or lack of experience and knowledge
unless they have been given supervision or instructions
concerning use of the fan by a person responsible for
their safety. Supervise children to ensure they do not
play with the fan.
17. Always place the Fan on a stable, flat, level surface
when operating to avoid the chance of the Fan
overturning.
OPERATING INSTRUCTIONS
1. Plug the Fan into an electrical outlet.
2. The Fan comes with (3) speeds.
3. Switch the Fan ON by turning the switch knob to speed
1, 2 or 3.
4. Switch the Fan OFF by turning the switch knob to 0.
5. Always unplug the Fan when it is not in use.
WARNING:
DO NOT use the ON/OFF switch as a means for
disconnecting the power when installing or servicing
the Fan.
ALWAYS unplug the Fan from the power source before
performing any maintenance and/or repair.
CARE AND MAINTENANCE
1. Unplug the Fan before cleaning.
2. DO NOT use any water for cleaning metal surfaces.
3. Slightly moisten a cloth then wipe off the surfaces of
the Fan.
4. DO NOT use lacquer thinner or similar solvents to clean
the plastic parts.
5. DO NOT use steel wool, wire brush, abrasive pads or
cleaners to clean the Fan.
BREAKER RESET
This is a safety feature. When you use a tool that draws
more amperage than the Fan’s receptacle (11 Amp) is
allowed to draw, the Circuit Breaker will trip. To reset,
unplug the tool that caused the Circuit Breaker to trip and
push the reset button.
IF AN EXTENSION CORD IS USED
1. The marked electrical rating of the cord set or
extension cord should be at least as great as the
electrical rating of the appliance.
2. The cord should be arranged so that it will not drape
over the countertop or tabletop where it can be pulled
on by children or tripped over unintentionally.
3. The extension cord must include a 3-prong
grounding plug.
To Next Page
Loading...