www.okinternational.com - 2 - P/N 7000-1370, Revision B
TABLE OF CONTENTS
PREFACE Safety and Regulatory Information
APR-5000 Series Main Unit Specifications
SECTION I Introduction and General Overview
SECTION II System Features and Accessories
SECTION III Set-Up Procedures
SECTION IV Software Operation
SECTION V Hardware Trouble Shooting, Optical and Head Calibration
SECTION VI Nozzles, Vacuum Pick-up Nozzle and Accessories
SECTION VII Calibration Kit and Spare Parts
SECTION VIII Site Preparation
SECTION IX Warranty and Service
PREFACE
SAFETY AND REGULATORY INFORMATION
WARNING
• TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE SYSTEM TO
MOISTURE.
• TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE FLAMMABLE
SOLVENTS NEAR OR ON THE SYSTEM WHILE CONNECTED TO POWER
SOURCE.
• TO PREVENT POSSIBILITY OF INJURY OR DAMAGE TO THE SYSTEM, DO
NOT OPERATE WITH ANY COVERS OR PANELS REMOVED.
• CHANGES OR MODIFICATIONS MADE TO THIS PRODUCT WITHOUT
EXPRESS APPROVAL FROM METCAL COULD VOID THE USERS
AUTHORITY TO OPERATE THE EQUIPMENT.
● Read and understand the entire Operator’s Manual before installation or
operation of the APR-5000. Heed all warnings on the system and in the operating
instructions.
● Use of the APR-5000 is intended only for the removal and placement of
electronic components on to printed circuit boards by properly trained personnel.
If you are not familiar with the proper and safe operation of the APR-5000, do not
operate until proper training has been obtained.
● The unit should be operated only from the type of power source indicated on the
serial number label.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...