EasyManua.ls Logo

Oki C5650 - Page 177

Oki C5650
249 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Oki Data CONFIDENTIAL
43827101TH Rev.2 177 /
Table 7-1-2 Service Call Error (2/7)
Error DescriptionMessage Cause Solution
Service call
042:Error
~
043:Error
045:Error
Power off/on
052:Error
Power off/on
070:Error
Power off/on
072:Error xx
Power off/on
073:Error xxxxxxxx
Power off/on
074:Error xxxxxxxx
075:Error xxxxxxxx
Service call
081: ERROR
Access to the Flash ROM directly
mounted on the CU PCB failed.
Does error reoccur?
Does error reoccur?
Is CU assembly set properly?
Is error recovered by replacing CU
PCB?
[On the C5650]
Is the CU Assy installed properly?
Is the error issued again?
[On the C6050/C6150]
Is the CU Assy installed
properly?
[Common]
Is CU assembly set properly?
EEPROM or FLASH has become
incapable of reading or writing.
Flash File System Error
Access to the Flash ROM
directly mounted on the CU
PCB failed. Conduct forced
initialization of the Flash
(Notice that NIC-F/W will also
be erased. It needs to be
written with the Maintenance
Utility after the initialization.)
Execute FLASH FORMAT of
MAINTENANCE MENU of
the System Maintenance
Menu. When "FLASH
FORMAT" is displayed,
release the key and wait till
"ONLINE" (approx. 2 min.).
If the symptom does not
change, replace the CU
PCB.
Power OFF/ON.
Replace PDL CU PCB.
Power OFF/ON.
Replace PDL CU PCB.
Set properly.
Replace GDI CU PCB.
Replace PU PCB
Redo the installation
properly.Change the PC for
another of higher grade, or
execute print again after
reducing the resolution.
Replace the GDI CU PCB.
Redo the installation
properly.Replace the PDL
CU PCB.
Reinstall or replace the
optional RAM DIMM.
Replace the interface
cable.Redo the installation of
the PC printer driver.
Set properly.
Replace CU PCB
Replace the CU PCB if
the problem remains
after cycling the power.
Flash File System
Error
DMA Abort Error
detected in Image
processor.
PSE firmware fault
detected.
Engine I/F Error
I/F error between
PU-CU.
Video Error.
A trouble was
detected during
image data
development.
(Illegal data
received)
Video Error Fault
detected when image
data is extended.
Parameterconsistency
check error
Ye s
Ye s
No
Ye s
No
No
Ye s
Ye s
No
Ye s
No
Ye s

Table of Contents

Other manuals for Oki C5650

Related product manuals