26
Printing on reflective sheeting
6
Load the media onto the media jack and
media support.
Notes
Be careful not to drop the media when loading it onto
the media jack.
Do not let the media jack fall. Otherwise it may be
damaged during use.
Do not grab the moving parts when holding the media
jack.
Otherwise, your ngers may get caught in the moving
parts, leading to an injury.
Media orientation
: printing surface
7
Turn the media jack’s handle clockwise to
raise the media until the roll tube is aligned
with the media holder.
Note
Pay attention not to insert you ngers into the moving
pantograph mechanism or otherwise touch it during
operation.
8
Insert the left media holder into the roll tube.
Notes
Pay attention not to unwind the media or damage the
ends of the roll media when inserting it into the media
holder.
Insert as far as it goes to secure the roll tube to the
media holder.
To Next Page
Loading...
