To Next Page

To Previous Page

45641001TH Rev.1

9-3 /

Oki Data CONFIDENTIAL

[B] Restore procedure

(1) Pressthe[ON/OFF]buttontoshutdowntheequipment.

(2) Connect the USB device [1] to the USB port [2] on the right upper cover.

[2]

[1]

Fig. 9-4

Notes:

Backing up cannot be performed with multiple USB device [1] connected at the

same time.

(3) Turn the power ON while pressing the [5] and [9] buttons simultaneously.

(4) If“3”issetfor08-8911,enterthepassword.

(5) Select“2.RestoreSRAMDatafromUSB”,andthenpressthe[START]button.

(6) Enterthepassword(max.15characters)whichhasbeensetin(6)of“[A]Backup

procedure”.

(7) Enter the serial number for the backup ﬁle.

(8) “RestoresuccessfullydoneRestarttheMFP”isdisplayedontheLCDscreenwhenthe

restoring has been properly completed.

(9) Pressthe[ON/OFF]buttontoshutdowntheequipment.

Notes:

To perform cloning with the SRAM data backed up before the ADI-HDD is initialized

orreplaced,followtheprocedurebelowaftertherestorationisnished.

(1) TurnthepowerONwhilepressing[3]andthe[CLEAR]buttonsimultaneously.

(2) Enterthepassword,andthenpressthe[OK]button.

 (IfnopasswordissetforService,pressthe[OK]buttonwithoutentering

anything.)

(3) Keyin[5]toselect“5.KeyBackupRestore”,andthenpressthe[START]button.

(4) Keyin[6]toselect“6.ADIKeyFROMtoSRAM”,andthenpressthe[START]

button.

(5) Waituntiltherestoringoftheencryptionkeyiscompleted.“OperationComplete”

is displayed.

(6) Then turn the power OFF.

Oki MB760dnfax Service Manual

Other manuals for Oki MB760dnfax