Oki MC770 - Page 420

45584901TH Rev.1
11-117 /
Oki Data CONFIDENTIAL
05/08 Mode Element
Sub
element
Item Subitem Code
Sub-
code
Details
Default
value
Acceptable
value
RAM Contents
Proce-
dure
08 Setting
Mode
System General 8750 Time to wait for print
image
0 0-1 SYS Sets whether the drum idling is executed or not when the
waiting for print image occurred. If there is the stain on
thebacksideofthepaper,setthevalueofthiscodeto
"1".Whenthevalueissetto"1",thenumberoftimesthe
equipmentstopsprintingmayincrease.
0:Waitingisenabled(8sec.)
1:Waitingisdisabled(0sec.)
1
08 Setting
Mode
System Mainte-
nance
8752 Switchover of
display of notice on
the control panel
when the time to
replace the unit has
come
0 0-1 SYS Specifies the contents of the message displayed on
the control panel when the time to replace the unit has
come.
0: Contact the service engineer for replacement (SRU)
1: Replacement by user (CRU)
1
08 Setting
Mode
System Mainte-
nance
Notification of
remaining amount of
toner
8755 Enable/Disable
setting
0 0-1 SYS 0: Disabled
1: Enabled
1
08 Setting
Mode
System Mainte-
nance
Notification of
remaining amount of
toner
8756 0 Remaining amount
at first notification
25 0-100 SYS 0 to 100% 4
08 Setting
Mode
System Mainte-
nance
Notification of
remaining amount of
toner
8756 1 Notification interval 10 1-25 SYS 1 to 25% 4
08 Setting
Mode
System User
interface
Card reading device 8758 Overwriting of login
at authentication
0 0-1 SYS Switches the enable/disable setting for the function to
overwrite the login information at the card authentication.
0: Disabled
1: Enabled
1
08 Setting
Mode
System General 8761 Retention of print
(spooling) data
0 0-1 SYS Use this code to retain and obtain the print data (spooling
data)ifproblemoccurs.Afterobtainingthedata,besure
to disable the setting.
0: Disabled (print data is deleted)
1: Enabled (print data is retained)
1
08 Setting
Mode
System Mainte-
nance
Display of remaining
amount of toner (for
RDMS/MMDT)
8762 0 K 0 0-100 SYS 0~100% 14
08 Setting
Mode
System Mainte-
nance
Display of remaining
amount of toner (for
RDMS/MMDT)
8762 1 C 0 0-100 SYS 0~100% 14
08 Setting
Mode
System Mainte-
nance
Display of remaining
amount of toner (for
RDMS/MMDT)
8762 2 M 0 0-100 SYS 0~100% 14
08 Setting
Mode
System Mainte-
nance
Display of remaining
amount of toner (for
RDMS/MMDT)
8762 3 Y 0 0-100 SYS 0~100% 14