Oki MICROLINE MX Series - Page 394

Index
394
Horiz Forms, 78
Host Interface, 73
Margins, 76
Max Line Width, 78
Page Length Rep, 78
PGL SFCC, 75
Power-Up Config, 79
Printer Protocol, 75
P-Series SFCC, 76
Ribbon End Point, 78
Save Config, 79
Select CPI, 76
Select LPI, 76
Vert Forms, 77
WLAN Address, 74
R
RBN AT END POINT message, 337
RBN SENSOR ERROR message, 336
Ready, Dataproducts Parallel Interface
Signals, 293
Receive Data (RD), RS-232, 303
Received CR, ANSI Emulation menu, 253
Received DEL, ANSI Emulation menu, 253
Reload paper, 32
REMOVE USED SPX message, 336
Renew Lifetime, WLAN Kerberos
menu, 121
Report Status, Auto Switching
submenu, 86
Request to Send
RS-232, 303
Serial submenu, 101
Requirements
power, 19
printer site, 20
Reset Cfg Names, 82
Reset Cmd CFG Ld, 216
ANSI Emulation menu, 252
Reset Cmd CFG Ld, PCL-II Emulation, 266
Reset Kerberos Password, WLAN
Kerberos menu, 120
Reset LEAP Password, WLAN LEAP
menu, 122
Reset LEAP User, WLAN LEAP menu, 122
Resistor configurations, terminating, 300
Resistors
installation, 301
removal, 301
Resp. Polarity
Centronics (Parallel) submenu, 90
Dataproducts (Standard & Long
Lines), 93
RESTORING BOOT CODE message, 336
RIB INVLD CMD* message, 336
RIB INVLD STATE* message, 337
Ribbon Action, PRINTER CONTROL, 286
RIBBON DRIVE message, 337
Ribbon End Point, 78
Ribbon End Point, PRINTER
CONTROL, 275
Ribbon Flipping, 14
Ribbon Log, 14
RIBBON NOT RECOGNIZED
message, 337