Oki ML1120 - Page 178

Technical Reference Guide – Command descriptions > 178
c: Sets control information.
DATA: Transmits barcode data.
The following table shows the barcode data number.
136 <= v1.v2 <= 150 150/180 331 <= v1.v2 <= 345 345/180
151 <= v1.v2 <= 165 165/180 346 <= v1.v2 <= 360 360/180
166 <= v1.v2 <= 180 180/180 361 <= v1.v2 360/180
181 <= v1.v2 <= 195 195/180
C MODULE WIDTH
bit 0 Sets check digit
0: Does not add check digit
1: Adds check digit
bit 1 Sets human readable characters
0: Prints
1: Does not print
bit 2 Sets flag character print position (Setting invalid)
0: Prints in centre
1: Prints in lower line
bit 3 (reserved)
bit 4 (reserved)
bit 5 (reserved)
bit 6 (reserved)
bit 7 (reserved)
BARCODE TYPE CHECK DIGIT
NOT ADDED
CHECK DIGIT
ADDED
EAN-13 0DH 0CH
EAN-8 08H 07H
Interleaved 2 of 5 01H – 32H 01H – 32H
UPC-A 0CH 0BH
SETTING RANGE SET
VALUE
(IN)
SETTING RANGE SET
VALUE
(IN)