Oki Pro1040 - Network Interface Specifications

- 104 -
Specifications
Network Interface Specifications
z
<Basic specifications>
Network protocol
• TCP/IP protocols
• EtherTalk protocols
z
<Connectors>
1000BASE-T/100 BASE-TX/10 BASE-T (automatic switching, simultaneous usage not possible)
Note
z
1000BASE-T is disabled in the default factory settings.
To use 1000BASE-T, do the following settings on the control panel.
[Admin Setup] > Input password > [Network Setup] > [Gigabit Network] > Set [Enable].
z
<Cables>
Unshielded twisted pair cable with RJ-45 connector (category 5e or better)
z
<Connector pin layout>
z
<Interface signals>
Pin
no.
Signal
name
Function
1 TRD+(0) Sending and receiving data 0 (+)
2 TRD-(0) Sending and receiving data 0 (-)
3 TRD+(1) Sending and receiving data 1 (+)
4 TRD+(2) Sending and receiving data 2 (+)
5 TRD-(2) Sending and receiving data 2 (-)
6 TRD-(1) Sending and receiving data 1 (-)
7 TRD+(3) Sending and receiving data 3 (+)
8 TRD-(3) Sending and receiving data 3 (-)