Oki Pro1040 - Roll Paper Specifications

- 106 -
Specifications
Roll Paper Specifications

Continuous paper (normal printing)
Paper feed direction
W2
D
C
L4
L5
L2
L6
L2
B
A
B
L2
A
A
B
Printing range
Winding direction
Outside winding: Printable surface faces out.
Inside winding: Printable surface faces in
Paper weight 0.07 to 0.25 mm (0.003 to 0.0098 inches)
Roll core Inner diameter: 76.2 mm (3 inches)
Outer diameter 203.2 mm (8 inches) or less
Other W2
:
Paper width 25.4 to 130 mm (1 to 5.12 inches)
L2
:
Paper length 12.7 to 1320.8 mm (0.5 to 52 inches)
L4
:
Cut size when in cut mode 101.6 mm (4 inches) or more
However, if the length of one label is less than 101.6 mm
(4 inches), then the shortest length is 101.6 mm
(4 inches) as multiple sheets are cut
L5
:
Upper edge cutting margin 2.12 mm (0.0835 inches)
L6
:
Lower edge cutting margin 2.12 mm (0.0835 inches)
A
:
Top margin 2.12 mm (0.0835 inches) or more
B
:
Bottom margin 2.12 mm (0.0835 inches) or more
C
:
Left margin 2.12 mm (0.0835 inches) or more
D
:
Right margin 2.12 mm (0.0835 inches) or more