Oki Pro1040 - Page 78

- 78 -
Printer Maintenance
20
Remove the F0 roller unit.
21
As you rotate the gears with one hand,
use Wiper moistened with cleaning fluid
(isopropyl alcohol) to clean the top and
bottom rollers on the F0 roller unit by
wiping in just one direction.
Memo
z
Lower the set lever on the rollers to rotate the top
and bottom roller at the same time.
22
Install the F0 roller unit, and fasten the
two screws.
23
Use Wiper moistened with cleaning
fluid (isopropyl alcohol) to wipe, in one
direction, the dirt off the sensor cover
(upper).
24
Use Wiper moistened with cleaning
fluid (isopropyl alcohol) to wipe, in one
direction, the dirt off the sensor cover
(lower).
25
Close the unwinder cover.
Note
z
There is a risk of pinching your fingers or hands
while closing the unwinder cover. Press on the top
of the unwinder cover to close it.
Reference
z
Refer to “Cleaning the Cutter Unit” (P.93)
regarding how to clean the cutter unit.