Oki PT330 - Preparation

Copyright (C) 2012 Oki Data Corporation
PT330/PT331 Printer Driver Installation Guide-1 1.0.0.1
10 of 33
*1) When using the OPOS driver with a USB or Parallel interfece
The new hardware is detected automatically when you turn on the printer.
Please follow the instructions below.
For Windows 7 / Server 2008 R2
(1)The message "Installing device driver software" is displayed in a balloon (lower right corner of
the screen).
(2)After a while, the message "Device driver software was not successfully installed" is displayed.
This is not a problem.
For Windows Vista / Server 2008
(1)The "Found New Hardware" screen is displayed, select [Don't show this message again for this
device].
* When "User Account Control" screen is displayed, select [Continue].
For Windows XP / Server 2003 / WEPOS / WEPOS2009
(1)The "Found New Hardware Wizard" screen is displayed. Select [No, not this time] and then click
[Next].
(2)When "What do you want the wizard to do?" is displayed, select [Install from a list or specific
location] and then click [Next].
(3)Select [Search for the best driver in these locations], clear the all checkbox and then click
[Next].
(4)When "Cannot Install this Hardware" is displayed, click [Don't prompt me again to install this
software] and then click [Finish].
For Windows 2000
(1)The "Found New Hardware Wizard" screen is displayed, click [Next].
(2)When "What do you want the wizard to do?" is displayed, select [Search for a suitable driver for
my device] and then click [Next].
(3)When [Locate Driver Files] is displayed, clear all checkboxes and then click [Next].
(4)When "Driver Files Search Results" is displayed, select [Disable the device] and then click
[Finish].