Copyright (C) 2012 Oki Data Corporation
PT330/PT331 Printer Driver Installation Guide-1 1.0.0.1
19 of 33
Whe
n using a USB interface connection
The USB port may vary depending on your system configuration.
Use the following procedure to change the printer driver setting and confirm it by printing a test page.
* See "3.1 How to use this manual" for instructions.
(1) Open the [Printer Folder].
(2) Open the "PT330-331 Raster" properties.
(3) Click the [Ports] tab.
(4) The following property screen is displayed.
Example: Change the port from "USB002" to "USB001"
←The [Printer] column is blank for unused ports.
Select the USB port you want to use.
(5) Click [Apply].
(6) Turn the printer power off.
(7) Turn the printer power on.
(8) Click the [General] tab and then click [Print Test Page].
(9) The test page will be printed.
To Next Page
Loading...