Copyright (C) 2012 Oki Data Corporation
PT330/PT331 Printer Driver Installation Guide-1 1.0.0.1
21 of 33
The screen on the left appears. Select
the port (*), make any other necessary
changes, and then click [OK].
This updates the printer settings and
completes the setup.
(For more information about the printer
setup, refer to the
“Application Programmer's Guide”.)
* See "How to specify the printer
port" below for instructions.
For LAN, change only the items
because the ports have already
been configured.
Launch OP OPOS Tester by running the
following program.
"\Drivers\OPOS\Sample\OP_OPO
S_Tester.exe"
Select an interface.
* For LAN
After selecting [PT330-331LAN] in the
interface selection, enter IP address of
the interface connected to the printer
in [IP Address].
Clicking [Print Test] prints a sample and
displays "Test: Success."
If "Test: Fail" is displayed, check the
printer power and interface.
How to specify the printer port
For a serial port connection
Select “PT330-331SERPRT” or “PT330-331SER2PRT” in [Device Name].
Select the connected port name (e.g. COM1) in [Port Name].
For a USB port connection
Select “PT330-331USBPRT” or “PT330-331USB2PRT” in [Device Name].
Select the printer's serial number in [Serial Number].
To obtain the serial number, follow the instructions in "4.2.2 Check serial number."
To Next Page
Loading...