19. Install the small white gear to the short axis.
Install the end cap and screw.
20. On the opposite side of the unit, fit the contact chip assembly and install the end cap.
OKIDATA B410 • 420 • 430 IMAGE UNIT & TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2013 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.uninetimaging.com
To Next Page
Loading...