Need help?Do you have a question about the Okuma GENOS M560-V and is the answer not in the manual?
General| Machine Type | Vertical Machining Center |
|---|---|
| Tool Capacity | 24 tools |
| X-Axis Travel | 1050 mm |
| Y-Axis Travel | 560 mm (22.0 in) |
| Z-Axis Travel | 510 mm |
| Spindle Speed | 12, 000 rpm |
| Spindle Motor Power | 11/7.5 kW (30 min/cont.) |
| Rapid Traverse Rate (X/Y/Z) | 36/36/36 m/min |
| Control | Okuma OSP-P300M |
| Machine Dimensions | 2, 800 x 2, 350 x 2, 400 mm |
| Maximum Table Load | 800 kg |
| Rapid Traverse Rate | 36 m/min |
Comprehensive specifications including travel, table, spindle, feed rate, motor, ATC, and remarks for the M560-V.
Visual representation of the M560-V machine, detailing its dimensions and key components.
Diagram and specifications for the installation of the M560-V, including power and clearances.
Recommendations for selecting an installation site, considering vibration, power sources, temperature, and humidity.
Details on concrete floor thickness, gaps, and when foundation work or anchoring is necessary.
Dimensions and load calculations for the M560-V foundation, including notes on site conditions.
Details on the specifications for foundation blocks and jack screws, along with safety guidelines for their use.
Specifies voltage, cycle, capacity, phase, and cable thickness required for the M560-V.
Outlines the required air flow rate, pressure, and moisture control for the machine.
Guidance on piping, filter drains, compressor selection criteria, and air quality grades.
Lists the specific oils and their amounts for the spindle cooling unit and oil-air lubrication unit.
Instructions and diagrams for lifting the machine using appropriate fixtures and balance beams.
Safety warnings and general precautions to be followed when lifting the machine, including wire-rope requirements.
Steps and safety instructions for lifting the coolant tank separately from the machine.
General guidance on lubrication, daily checks, and using specified oils for machine preparation.
A detailed chart specifying lubrication points, service intervals, and types of oils/greases for various machine components.
Explanation of symbols used in the lubrication chart, including oil level, lubrication, change, and inspection indicators.
Lists major brand lubricating oils and greases recommended for different machine applications (gears, bearing, slideway, hydraulic, grease).
Instructions for supplying oil to the oil-air lubrication unit, including specified oil, tank capacity, and maintenance intervals.
Details on oil specification, amount, and change interval for the spindlehead cooling unit.
Method and amounts for greasing ball screws, linear guides, and the ATC magazine using a standard greasing gun.
To Next Page