FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help important announcement.
RF Exposure
The portable device is designed to meet the requirements for exposure to radio waves established by the FCC RF exposure
guidelines. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value is
measured at a distance of 0mm between the radiator and the Head. The highest reported Head SAR value: 0.66W/kg.
RF Exposure
The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These
requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value is measured at a
distance of 0mm between the radiator and the Head. The highest reported Head SAR value: 0.66W/kg.
Le dispositif portable est conçu pour répondre aux exigences d’exposition aux ondes radio établies par lise. Ces
exigences fixent une limite das de 1,6 W/kg en moyenne sur un gramme de tissu. La valeur das la plus élevée est mesurée
à une distance de 0mm entre le radiateur et la tête. Le das maximal déclaré est de 0,66 w /kg.
FCC ID：2A9AR-OLA06L FCC ID：2A9AR-OLA06R IC：29727-OLA06L IC：29727-OLA06R
HVIN:OLA06L HVIN:OLA06R XXXXX CMIIT ID：XXXXXXXX
Important Note:
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 0cm between the radiator and your
body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Warning:
1. Don’t place the product into a liquid environment or avoid the product exposed to high humidity
2. Avoid extrusion to avert the damage to the product
3. Don’t attempt to dismantle the product. Put the product in a cool and dry place to keep it dry if stored for a long time
4. Avoid touching the strong magnet to prevent the magnetic headset from being demagnetized.
5. Avoid the dusty, wet and dirty environment where the electronic circuit of the equipment may be damaged if being used.
6. Don’t Use the equipment at the moment of thunderstorm because the thunderstorm may incur equipment fault or shock
hazard.
7. Don’t use the equipment when riding a motorcycle or a bicycle,driving a car or crossing the road to ensure your safety.
8. Keep the equipment out of reach of children or pets to avert the damage.
9. Don’t wash the equipment with chemical cleanser or strong detergent
Don’t Listen to the voice under high sound pressure and high volume for a long time to prevent the
possible hearing impairment when the headset is used.
-English: "
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device."
- French: "
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
To Previous Page
Loading...