EasyManua.ls Logo

Oldsmobile 1995 Aurora

Oldsmobile 1995 Aurora
372 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AMEM:
Press this button to change between the AM,
FM1 and FM2 bands. The display will show which band
you
are on. If you press this button while
a
tape or CD
is
playing, the tape or
CD
will stop and the radio
will
return
to
the AM or
FM
band that
you
were on.
TUNE:
Press lightly
on
this knob to release it from its
recessed position. Turn
it
to
tune
in radio stations. You
may push the knob back in to return it to its recessed
position when not
in
use.
To
Preset Radio Stations
The five pushbuttons labeled
1-5
can be used to preset up
to
15
radio stations (five AM, five FM
1
and five FM2).
1. Tune
in
the
station
you
want to store.
2.
Press TONE to select the setting that you prefer.
3.
Press and hold one of the five pushbuttons
until
the
display shows a channel number. The radio will mute
until the channel number is displayed. Whenever you
press that button again, the preset station and tone
setting will return. Always check whether you’re in
AM, FMl or FM2.
SEEK
A/V:
When you press
SEEK
while playing the
radio,
the
radio
will
search for the next higher or lower
station and stop. The radio will be muted while seeking.
SCAN:
When you press SCAN while playing the radio,
the radio will
go
through each station, pausing for a few
seconds at each station. Press SCAN again to stop on
a
station. The radio will be muted while scanning and
“SCAN”
will
appear on the display.
When you press SCAN and hold
it
for about two seconds
until the display shows “PSCAN’ (Preset Scan), the radio
will scan only stations that you’ve preset with your radio
pushbuttons. Press SCAN again to stop
on
a
station.
RCL (Recall):
When the ignition is off, press RCL to
display the time. When the radio is on, press RCL to
switch the display between the radio station and the
time. After
five
seconds the display will return to its
normal display.
The radio can be set
so
that either the time or radio
station is normally displayed when the radio is playing.
To
do
this, press RCL
to
display the time or radio
stations as desired, then hold
RCL
down
until
the
display flashes.
3-10

Related product manuals