BAL
(Balance):
Press this button lightly to release
it
from its recessed position. Turn
it
to adjust the right and
left speaker balance.
As
you turn the knob you will feel
the center position. Push the knob back in to return
it
to
its recessed position.
FADE:
Press this button lightly to release
it
from its
recessed position, then pull
it
out to its
fully
extended
position. Turn it to the right to increase front speaker
volume. Turn it to
the
left to increase rear speaker
volume.
As
you turn the knob you will feel the center
position. Push the knob back
in
to return it to its
recessed position.
To
Play
a Cassette Tape
With the ignition on, insert
the
tape and
it
will
begin
playing. The audio system will turn on automatically.
Your tape player is designed to work best
with
tapes that
are
30
to 45 minutes long on each side. Longer tapes
may not work as well.
Note that when a tape is inserted, “TP? will be
displayed. When the tape is playing, a box
will
appear
around
“TP’
in
the display along
with
an arrow to show
whether the
top
or bottom
of
the tape is playing.
Any
time a tape is inserted, the top side will play first.
If
LI
high-bias metal or CrO2 tape is played, “HI-BIAS”
will appear in the display and the equalization
will
be
adjusted automatically.
If
you
select
a
tone setting, it
will be activated each time
you
play a tape.
If “Cln” (Clean) appears on
the
display when you insert
your cassette tape, your cassette player needs to be
cleaned. It will still play cassette tapes, but
it
should be
cleaned to prevent damage to your cassette tapes and the
cassette tape player. See “Care
of
Your Cassette Tape
Player” later
in
this section. After you have cleaned the
cassette tape player, press and hold EJECT for five
seconds to reset the Cln indicator. The radio will display
&‘---’?
to show that the clean feature has been reset.
If “Err” or
“E” and
a
number appear on the display
at
any time, an error has occurred. See “Cassette
Tape
and
CD Errors” later in this section.
NR
(Noise
Reduction):
This radio has Dolby@B Noise
Reduction to reduce background noise on Dolby@B
encoded tapes. Press this button to reduce background
noise on your tape. The Dolby symbol
00
will appear
in the display. Dolby@ Noise Reduction is manufactured
under license from Dolby Laboratories Licensing
Corporation. Dolby@ and
the
00
symbol are
trademarks
of
Dolby Laboratories Licensing
Corporation.
3-20
To Next Page
Loading...
