To
Add
Coolant
If
you need more coolant, add the proper mix
at the
surge
tank,
but only when the engine is cool.
When replacing the pressure cap, make sure it is tight.
Thermostat
Engine coolant temperature is controlled by a thermostat
in the engine coolant system. The thermostat stops the
flow
of
coolant through the radiator until the coolant
reaches a preset temperature.
When you replace your thermostat, an AC@ thermostat
is recommended.
Power Steering Fluid
How To
Check
Power Steering Fluid
When the engine compartment is cool, unscrew the cap
and wipe the dipstick with a clean rag. Replace the cap
and completely tighten it. Then remove the cap again
and look at the fluid level on the dipstick.
The level should be at the
FULL
COLD
mark. Add
enough fluid to bring the level up to the mark.
A
fluid loss in this system could indicate a problem.
Have the system inspected and repaired.
6-21
To Next Page
Loading...
