0
If
a
ring forms after spot cleaning, clean the entire
area immediately or
it
will set.
Using Foarn-']lSrpe Cleaner on Fabric
0
0
0
0
0
0
Vxuum
and brush the area to remove any loose dirt.
Always clean a whole trim panel or section. Mask
surrounding trim along stitch or welt lines.
Mix Multi-Purpose Powdered Cleaner following the
directions
011
the
container label.
Use suds only and apply with a clean sponge.
Don't saturate the material.
Don't rub
it
roughly.
As
soon
as
you've cleaned the section, use
a
sponge
to remove the suds.
Rinse the section with
a
clean, wet sponge.
Wipe off what's left
with
a slightly damp paper towel
or cloth.
Then dry
it
immediately with
a
blow dryer or a heat
lamp.
NOTICE:
I
Be careful.
A
blow dryer may scorch the fabric.
I
0
Wipe
with
a clean cloth.
Using Solvent-Type Cleaner
on
Fabric
First, see
if
you have to use solvent-type cleaner at all.
Some spots and stains
will
clean off better
with
just
water and mild soap.
If
you need
to
use
a
solvent:
0
Gently scrape excess
soil
from the
trim
material
with
a clean, dl111 knife or scraper. Use very little cleaner,
light pressure and clean cloths (preferably
cheesecloth), Cleaning should start at the outside
of
the stain, "feathering" toward the center. Keep
changing to
a
clean section of the cloth.
0
When you clean
a
stain from fabric, immediately dry
the area
with
a blow dryer to help prevent a cleaning
ring.
(See
the previous
NOTICE.)
6-44
To Next Page
Loading...
