If
you accidentally use
a
key that has a damaged or
missing resistor pellet, the starter won’t work and the
SECURITY light
will
flash and the CLEAN
KEY.
..
WAIT
3
MINUTES
message will appear. But you
don’t have to wait three minutes before trying another
ignition key.
See
your Aurora retailer
or
a locksmith
who
can service
the PASS-Key@II to have a new key made.
If
you’re ever driving and
the
SECURITY
light comes
on
or PASS-KEY
SYSTEM
FAULT appears, you will
be
able to restart your engine
if
you
turn
it
off.
Your
PASS-Key@II system, however,
is
not
working properly
and must be serviced by your Aurora retailer. Your
vehicle
is
not protected by the PASS-Key@II system.
If
you lose or damage a PASS-Key@II ignition key, see
yo~~r Aurora retailer or a locksmith who can service
PASS-Key@II to have a new key made.
New
Vehicle
44Break-In”
NOTICE:
Your modern Aurora doesn’t need an elaborate
“break-in.” But it
will
perform better in the long
run if you follow these guidelines:
0
Don’t drive at any one speed
--
fast or
slow
--
for the first
500
miles
(804
km).
Don’t make full-throttle starts.
200 miles
(322
km) or
so.
During this time
your new brake linings aren’t yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this “breaking-in?’ guideline every
time you get new brake linings.
0
Don’t tow
a
trailer during “break-in.” See
“Towing
a
Trailer” in the Index for more
information.
Avoid making hard stops for the first
2-14
To Next Page
Loading...
