RECALL:
Press this button briefly to recall the station
being played or to display the clock. To change what is
normally shown on the display (station or time), press
the RECALL button until you see the display you want,
then hold the RECALL button until the display flashes.
If
you press the button when the ignition is
off,
the clock
will show for a few seconds.
Finding a Station
AM-FM:
Press this button to switch between AM, FM1
and
FM2.
The display shows your selection.
TUNE:
Press
this
knob lightly
so
it extends. Turn it to
choose radio stations. Push the knob back into its stored
position when you’re not using it.
SEEK:
Press the up or down arrow to go to the next
higher or lower station and stay there. The sound will
mute while seeking.
SCAN:
Press this button and release it to listen to
stations for a few seconds. The radio will go to a station,
stop for a few seconds, then go on to the next station.
Press the button again to stop scanning. The sound will
mute while scanning, and
SCAN
will appear on the
display.
If
you press
SCAN
for more than
two
seconds,
the radio will change to
P
SCAN
mode.
P
SCAN
will
appear on the display.
PUSHBUTTONS:
The
five
numbered pushbuttons let
you return to your favorite stations. You can set up to
15
stations (five AM, five
FM1
and five
FM2).
Just:
1.
Turn the radio on.
2.
Press
AM-FM
to select the band.
3.
Tune in the desired station.
4.
Press and hold one of the five numbered buttons.
The sound will mute. When it returns, release the
button. Whenever you press that numbered button,
the station you set will return.
5.
Repeat the steps for each pushbutton.
P
SCAN:
Press
SCAN
for more than two seconds, and
P SCAN will appear on the display. The radio will go to
the first preset station stored on your pushbuttons, stop
for a few seconds, then go on to the next preset station.
Press
SCAN
again to stop scanning.
3-7
To Next Page
Loading...
