Setting the Tone
BASS:
Press
this
knob lightly
so
it extends. Turn the
knob to increase or decrease bass. When you use this
control, the radio’s tone setting will switch to manual.
TREB:
Press
this
knob lightly
so
it extends. Then pull
the knob all the way out. Turn the knob to increase or
decrease treble. When you use this control, the radio’s
tone setting will switch to manual.
If
a station is weak or
noisy, you may want to decrease the treble.
Push these knobs back into their stored positions when
you’re not using them.
TONE:
This
feature allows you to choose preset bass
and treble equalization settings designed for jazz, vocal,
pop, rock and classical stations.
JAZZ
will appear on the
display when you first press TONE. Each time you press
it, another setting will appear on the display. Press it
again after CLASSIC appears and
MANUAL
will
appear. Manual tone control will return to the BASS and
TREB knobs. Also, if you use the BASS and TREB
knobs,
control will return to them and
MANUAL
will appear.
Adjusting the Speakers
BAL:
Press this knob lightly
so
it extends. Turn the
knob to move the sound to the left or right speakers.
The middle position balances the sound between
the speakers.
FADE:
Press the knob lightly
so
it extends. Then pull
the knob all the way out. Turn it to move the sound to
the front or rear speakers. The middle position balances
the sound between the speakers.
Push these knobs back into their stored positions when
you’re not using them.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30
to
45
minutes long on each side. Tapes longer than
that are
so
thin
they may not work well in this player.
The longer side with the tape visible should face to the
right. If the ignition is on, but the radio is
off,
the tape
can be inserted and will begin playing.
If
you hear
nothing but a garbled sound, the tape may not be in
squarely. Press EJECT to remove the tape and start over.
To Next Page
Loading...
