SEEK:
Press the up or down
arrow
to search for the
next or previous selection on the tape. Your tape must
have at least three seconds of silence between each
selection for SEEK to work.
SCAN:
Press this button to listen to each selection for a
few seconds. The tape will go to the next selection, stop
for a few seconds, then go on to the next selection. Press
this button again to stop scanning. The sound will mute,
SCAN will appear on the display and the tape direction
arrow will blink while scanning.
AM-FM:
Press this button to play the radio when
a tape is
in
the player. The tape will stop but remain
in
the player.
TAPE AUX:
If
you have a tape inserted and the radio is
playing, press TAPE
AUX
to play your tape. To return
to the radio while a tape
is
playing, press
AM-FM.
The
inactive tape will remain safely inside the radio for
future listening.
EJECT
Press this button to remove the tape. The radio
will play. EJECT may be activated with either the
ignition or radio
off.
Cassettes may be loaded with the
radio and ignition
off
if
this
button is pressed first.
If
you leave a cassette tape in the player
while
listening to
the radio, it may become wm.
CLN:
If
this message appears on the display, the
cassette tape player needs to be cleaned. It will still play
tapes, but you should clean it as soon as possible to
prevent damage to the tapes and player. See “Care of
Your Cassette Tape Player” in the Index. After you clean
the player, press and hold EJECT for five seconds to
reset the CLN indicator. The radio
will
display
---
to
show the indicator was reset.
To Next Page
Loading...
