PUSHBUTTONS:
The five numbered pushbuttons let
you return to your favorite stations. You can set up to
15
stations (five
AM,
five FM1 and five FM2). Just:
1.
Turn the radio on.
2.
Press AM-FM to select the band.
3. Tune in the desired station.
4.
Press TONE to select the equalization that best suits
the type of station selected.
5.
Press and hold one of the five numbered buttons.
The sound will mute. When it returns, release the
button. Whenever you press that numbered button,
the station you set will return and the tone that you
selected will also be automatically selected for
that button.
6.
Repeat the steps for each pushbutton.
P
SCAN:
Press SCAN
for
more than two seconds, and
P SCAN will appear on the display. The radio will
go
to
the first preset station stored on your pushbuttons, stop
for a few seconds, then
go
on to the next preset station.
Press
SCAN
again to stop scanning.
Setting the Tone
BASS:
Press thls knob lightly
so
it extends. Turn the
knob to increase or decrease bass. When you use this
control, the radio's tone setting will switch to manual.
TREB:
Press this knob lightly
so
it extends. Then pull
the knob
all
the way out. Turn the knob to increase or
decrease treble. When you use this control, the radio's
tone setting will switch to manual.
If
a station is weak or
noisy, you may want to decrease the treble.
Push these knobs back into their stored positions when
you're not using them.
TONE:
This
feature allows you to choose preset bass
and treble equalization settings designed for jazz, vocal,
pop, rock and classical stations.
JAZZ
will appear on the
display when you first press TONE. Each time you press
it, another setting will appear on the display. Press it
again after CLASSIC appears and MANUAL will
appear. Tone control will return to the
BASS
and
TREB
knobs.
Also,
if
you use the
BASS
and TREB knobs,
control will return to them and MANUAL will appear.
To Next Page
Loading...
