Playing
a
Cassette
Tape
Your tape player is built to work best with tapes that are
up to
30
to
45
minutes long on each side. Tapes
longer than that are
so
thin they may not work well in
this player. The longer side with the tape visible should
face to the right.
If
the ignition is on, but the radio is
off,
the tape can be inserted and will begin playing. If
you hear nothing but a garbled sound, the tape may not
be in squarely. Press the eject button, located next to
the cassette tape slot, to remove the tape and start over.
While the tape is playing, use the VOLUME, POWER,
AUDIO, AUTO EQ, and the SEEK controls just as
you do for the radio. The display will show TAPE and
an arrow showing which side of the tape is playing. The
tape player automatically begins playing the other
side when it reaches the end of the tape.
Your tape bias is set automatically when a metal or
chrome tape is inserted.
If
you want to insert a
tape while the ignition
is
off,
first press the button with
the eject symbol on it or the RCL knob.
ii
an error appears on tne rauio uispiay, the tape won’t
play because of an error. See “Cassette Tape
Messages” later in this section.
1
REV
(Reverse): Press this pushbutton to reverse the
tape rapidly. Press it again to return to playing speed.
The radio will play while the tape reverses. You
may select stations during reverse operation by using
TUNE, SEEK and SCAN.
2
FWD
(Forward):
Press this pushbutton to advance
quickly to another part of the tape. Press this pushbutton
again to return to playing speed. The radio will play
while the tape advances. You may select stations during
reverse operation by using TUNE, SEEK and SCAN.
5
SIDE:
Press this pushbutton to play the other side of
the tape.
AUTO
EQ
(Automatic
Equalizer): Press AUTO EQ to
select the desired equalization setting while playing
a cassette tape. The equalization will be automatically
set whenever you play a cassette tape. See “AUTO EQ”
listed previously for more information.
<
SEEK
>
:
Your tape must have at least three
seconds
of silence between each selection for seek to
the next or the previous selection on the tape. You can
skip as many as nine selections up or down on the
tape. Choose how many selections you want to skip,
then press the right or left SEEK arrows that many
times. The number of selections to be skipped
wiii
appear
on the dispiay.
,l,Arl,
rnee
thm
.-;-ht
+h,,
I.4t
--I-...
+-
---,-L.
C--
mnwl
I\.
Prbad
La
aci
I
ryt
II
uI
u
IC
1Gl1
altuvv
tu
at;alu
I
IuI
3-61
To Next Page
Loading...
