Reprogramming a Single HomeLink@
Button
To program a device to HomeLink@ using a HameLink@
button previously trained, follow these steps:
1.
Press and hold the desired HomeLink@ button.
Do
not release the button.
2.
The indicator light
will
begin to flash after
20
seconds. While still holding the HomeLink@
button, proceed with Step
2
under “Programming
HomeLink@.”
Resetting Defaults
To
reset HomeLink@ to default settings do the following:
1.
Hold down the two outside buttons for about
20
seconds until the indicator light begins to flash.
2.
Continue to hold both buttons until the HomeLink@
indicator light turns
off.
3.
Release both buttons.
For questions or comments, contact HomeLink@ at
1-800-355-351
5,
or on the internet at
www.homelink.com.
2-53
To Next Page
Loading...
