2-54
To adjust the mirror, use one of the four arrows located
on the control pad to move the mirror in the direction
you want it to go. When finished adjusting the mirrors,
leave the L/R selector switch in the center position, to
prevent unwanted mirror movement in case the control
pad is accidentally bumped while driving. Adjust each
outside mirror so that you can see a little of your
vehicle, and the area behind your vehicle.
If your vehicle is equipped with the memory function,
the mirrors and driver’s seat position, can be stored into
memory. See “Memory Seat and Mirrors” in the Index.
Parallel Park Assist Mirror (If Equipped)
If you have the memory seat and mirrors feature, the
passenger’s outside rearview mirror also includes a
tilt-down feature that operates when the shift lever is
in REVERSE (R). When the vehicle is shifted out of
REVERSE (R), the passenger’s mirror will return to
its original position after a five
-second delay. This
delay prevents movement of the mirror if multiple
gear transitions (REVERSE (R) to DRIVE (D)
to REVERSE (R)) occur during a parallel parking
maneuver. This feature can be programmed on or
off through the DIC. See “Driver Information Center”
or “Personalization Features” in the Index for
programming instructions. Vehicles are delivered with
this feature off.
Convex Outside Mirror
Your passenger’s side mirror is convex. A convex
mirror’s surface is curved so you can see more from
the driver’s seat.
CAUTION:
A convex mirror can make things (like other
vehicles) look farther away than they really are.
If you cut too sharply into the right lane, you
could hit a vehicle on your right. Check your
inside mirror or glance over your shoulder
before changing lanes.
Heated Outside Rearview Mirror
(If Equipped)
When you operate the rear window defogger, the heated
driver’s and passenger’s outside rearview mirrors also
warm up to help clear them of ice and snow. See “Rear
Window Defogger” in the Index.
To Next Page
Loading...
