6-46
Rear Turn Signals, Stoplamps, Taillamps
and Back-up Lamps
1. Open the trunk.
2. Turn the screws located inside of the trunk
counterclockwise and remove them.
3. Remove the plastic trim piece from the trunk.
4. Pull the carpeting away from the rear corner of
the trunk.
5. Remove the three nuts holding the lamp in place and
remove the lamp assembly.
6. While pressing the release, turn the bulb socket
assembly counterclockwise to remove it from the
lamp assembly.
7. Pull the bulb straight out to remove it from
the socket.
8. Replace the bulb and reverse the steps to reinstall the
lamp assembly.
To Next Page
Loading...
