Using HorneLink@
Press and hold the appropriate HomeLink@ button for at
least half
of
a second. The indicator light will come
on while the signal is being transmitted.
Erasing HorneLink@ Buttons
To
erase programming from the three buttons do the
following:
1.
Press and hold down the two outside buttons until
the indicator light begins to flash, after 20 seconds.
2.
Release both buttons.
Do
not hold for longer than
HomeLink@ is now in the train (learning) mode and can
be programmed at any time beginning with Step
2
under “Programming HomeLink@.”
Individual buttons can not be erased, but they can be
reprogrammed. See “Reprogramming a Single
HomeLink@ Button” next.
30 seconds.
Reprogramming
a
Single HomeLink@
Button
To program a device to HomeLink@ using
a
HomeLink@
button previously trained, follow these steps:
1. Press and hold the desired HomeLink@ button.
Do
not release the button.
2. The indicator light will begin to flash after
20
seconds. While still holding the HomeLink@
button, proceed with Step
2
under “Programming
HomeLink@.”
Resetting Defaults
To reset HomeLink@ to default settings do the following:
1.
Hold down the two outside buttons for about
20
seconds until the indicator light begins to flash.
2.
Continue to hold both buttons until the HomeLink@
indicator light turns
off.
3. Release both buttons.
For questions or comments, contact HomeLink@ at
1-800-355-351
5,
or on the internet at
www.homelink.com.
2-44
To Next Page
Loading...
