Headlamp aiming
is
done with the vehicle’s low beam Headlamp Horizontal Aiming
lamps. The high beam lamps will be correctly aimed
if
the low beam lamps are aimed properly. Turn the horizontal aiming screw
(A)
until the
The headlamp aiming devices are under the hood near
indicator
(B)
is lined up with zero.
the headlamps.
If you believe your headlamps need horizontal (lefvright)
adjustment, follow the horizontal aiming procedure.
If
Once the horizontal aim is adjusted, then adjust the
you believe your headlamps need only vertical vertical aim.
jupiaownj aajustment, ioiiow oniy tne verticai aiming
procedure.
Adjustment screws can be turned with an
E8
Torx@
socket or T15 Torxa screwdriver.
5-51
To Next Page
Loading...
