SCAN: Press and hold
SEEK
for two seconds
until
SCAN appears on the display. SCAN allows
you
to
listen to stations for
a
few seconds. The receiver will
continue to scan and momentarily stop at each station
until
you
press the button again. The sound will mute
while scanning.
PUSHBUTTONS: The six numbered pushbuttons let
you return to your favorite stations.
You
can set up to
18
stations (six
AM,
six
FM
1
and six
FM2).
Just:
1.
2.
3.
4.
5.
6.
Turn the radio on.
Press AM-FM to select the band.
Tune in the desired station.
Press AUTO TONE
to
select the setting you prefer.
Press and hold one of
the
four pushbuttons. The
sound will mute. When
it
returns, release the button.
Whenever you press that numbered button, the
station you set will return and the tone you selected
will be automatically selected for that button.
Repeat the steps for each pushbutton.
P.SCAN: The preset scan button lets you scan through
your favorite stations stored on your pushbuttons. Select
either the
AM,
FM1
or
FM2
mode and then press
PSCAN. It will scan through each station stored on your
pushbuttons and stop for
a
few seconds before continuing
to scan through all of the pushbuttons. Press P.SCAN
again or one of the pushbuttons to stop scanning to listen
to
a
specific stored station. P.SCAN will light up on the
display while
in
this mode. If one of the stations stored on
a
pushbutton is too weak for the location
you
are in, the
rdio
will
skip the preset station and the radio display will
show the channel number
(P1
through P6) for several
seconds before advancing to the next preset station.
Setting the
Tone
BASS: Press lightly on this knob to release
it
from its
stored position. Turn the knob clockwise to increase
bass and counterclockwise to decrease bass. When the
BASS
control is rotated, the
AUTO
TONE setting will
change to
MAN.
TREB:
Press lightly on this knob to release it from
its
stored position. Turn the knob clockwise to increase
treble and counterclockwise
to
decrease treble. When
the TREB control is rotated, the
AUTO TONE setting
will
change to MAN. If
a
station
is
weak or noisy, you
may want to decrease the treble.
Push these knobs back into their stored positions when
you’re not using them.
3-10
To Next Page
Loading...
