/1
Features
&
Controk
76
down. Of course, applying the brake
takes you .out of cruise control. Many
drivers find this to be too much trouble
and don’t use cruise control on steep
hills
*
To
Get Out
of
Cruise Control
There are two ways to turn
off
the
cruise control:
Step lightly on the brake pedal;
OR
Move the cruise switch to
OFF.
To
Erase
Cruise Speed
Memory
When you turn off the cruise control or
the ignition, or shift into
P
(Park), your
cruise control set speed memory is
erased.
Pulse Windshield. Wipers
You
control the windshield wipers by
turning the band marked
WIPER.
For a single wiping cycle, turn the band
to
MIST.
Hold it there until the wipers
start, then let go. The wipers will stop
after one cycle. If you want more cycles,
hold the band on
MIST
longer.
For steady wiping at low speed, turn the
band away from you to the
LO
position.
For high-speed wiping, turn the band
further, to
HI.
To stop the wipers, move
the band to
OFF.
Remember that damaged wiper blades
may prevent you from seeing well
enough to drive safely. To avoid
damage, be sure to clear ice and snow
from the wiper blades before using
them.
If
they’re frozen to.the
windshield, carefully loosen or thaw
them.
If
your blades do become
damaged, get new blades or blade
inserts.
Heavy snow or ice can overload your
wipers.
A
circuit breaker will stop them
until the motor cools. Clear away snow
or ice to prevent an overload.
You
can set the wiper speed for a long
or short delay between wipes. This can
be very useful
in
light rain
or
snow.
Turn the band to choose the delay time.
The closer to
LO,
the shorter the delay.
To Next Page
Loading...
