Olimpia splendid UNICO ART - Air Ducts and External Grids Assembly; Preparing Machine Holes

EN - 14
ENGLISH
When the condensate drainage is tted, pay much attention not to compress
the rubber hose.
In the event of operation during the winter with temperatures equal to or lower than 0° C, make
sure that the condensate drain pipe is protected from freezing in order to ensure draining.
In the event of prolonged operation during the winter with temperatures below 5°C, install the
optional basin heater kit.
2.4.3 - Assembly of the air ducts and external grids
• Afterdrillingtheholes(withthecoredrill),inserttheplasticsheet(H)suppliedwiththeairconditioner
(g.11)insidethem.
 Sincethesheet(H)wasmadefor202mmholes,youwillhavetocutoff130mmfromthelongsideof
thesheetforthe162mmholes(g.11).
The sheets must be 65 mm shorter than the length of the wall.
• Rollthesheet(H)andinsertitintothehole,payingattentiontothesplicingline,which must always
face upwards. (g.12).
 Useanordinarycutterfortheforegoingoperation(g.12).
To position the external grids, proceed as follows:
a. Applytheseal(G)tothewallange(D),ensuringitlinesupwiththeouteredgeoftheangeasindicated
inthegure13.
b. Fixthetwoangesusing2pegshavingadiameterof6mmandcheckthatthetwoxingholesare
horizontal(g.14-15-16).
c. Fitthesmalleyeletofthespring,withthelongstem,onthecappin(onbothcomponents)(g.17).
d. Insertthetwocaps(withspring),onthefrontpartoftheexternalgrid,onitstwohousings,pullinguntil
itclicks(g.18)andcouplethetwochainstothelargeeyeletofthespring.
e. Using one hand, grip the two chains connected to the grid;
f. Bendtheexternalgridsback,grippingthemwithyourfreehandwheretheybend,andinsertyourngers
insidethesinglens(g.19).).
g. Insert your arm into the pipe until the grid protrudes completely outwards.
h. Reopenthegrid,beingcarefultokeepyourngersinsidethens.
i. Turnthegriduntilthensarefullyhorizontalandtilteddownwards.
l. Pullthechain,tensioningthespring,andcouplethechainringtothepinoftheinnerangethrough
whichthepipespass(g.20).
m. Use hand shears to cut off any excess chain links.
Use exclusively the supplied grids (F), or grids with like characteristics.
2.4.4 - Preparing the holes on the machine
If Ø 202 mm holes are being used, work as follows:
a. If 162 mm pipes are being used, the removal operation of part of the rear cover must not be performed.
b. Useplierstobreakthepreblankingoftherearcover(g.21-A).
c. Then, rotate the cover part to be removed back and forth with your hand until you break the remaining
preblankedpart(g.21-B).
d. Trimexcessiveinsulatingmaterialremainedinsidetheholeusinganutilityknife(g.21-B).