UNICO ART R410A
LED D LED B H
LED C LED A
G
40
EN - 17
ENGLISH
After performing the mechanical operations for changing the air outlet
ap,itisnecessarytocongurethecontrolelectronicsofthemachine
(seeg.40):
a. Connect the power supply line.
b. Make sure the machine is in stand-by, LED A on.
c. Keep the reset button H pressed until an acoustic signal
sounds.
d. HIGH WALL CONFIGURATION: press and hold button
H again until LED C(yellow)lightsup.
FLOOR CONFIGURATION: press and hold button H
again until LED B(green)lightsup.
e. Release the display button H and wait a few seconds
untilthestand-bycongurationisrestored,LED A on.
3 - USE
3.1 - WARNINGS
The installation and electrical connection of the air conditioner should be carried out by specialized
personnel who possess the requisites set forth by law.
The installation instructions are contained in the appropriate paragraph of this manual.
No structural object (furniture, curtains, plants, leaves, blinds, etc.) should ever
obstruct the normal ow of air from either the internal or external gratings.
• Never lean or, worse yet, sit on the casing of the air conditioner as this could cause serious
damage to the external parts.
• Do not move the air outlet ap by hand. Always use the remote control to adjust bafe position.
• If the unit leaks water, switch it off immediately and disconnect it from the power mains. Call
the nearest service centre.
• When the air conditioner is heating, it has to periodically eliminate any ice that could form on
the external battery. While it is doing this, the machine keeps running but does not heat the
room. This lasts for a brief period of time, from 3 to a maximum of 10 minutes.
• Clean the air lter periodically, as described in the specic paragraph (4.1.2).
The air conditioner must not be installed in rooms where explosive gasses de-
velop or where there are conditions of heat and humidity beyond the maximum
limits indicated in the installation manual.
To Next Page
Loading...
