EasyManua.ls Logo

Olimpia splendid Unico Easy HP - Remote Control Operation and Functions

Olimpia splendid Unico Easy HP
84 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
42
I
GB
F
D
RIMOZIONE DEL
TELECOMANDO
Per rimuovere il telecomando
dal climatizzatore ènecessario
utilizzare l’apposita chiavefornita
acorredo. Inserire lachiavenella
sede posta sul pannello comandi e
ruotarla in senso antiorario di circa
90°(g.14).Estrarreiltelecomando
dalla sede afferrandolo per la parte
posterioreefacendololeggermente
ruotare su se stesso. Per
riposizionare il telecomando nella
suasede eseguirel’operazione
inversa.Nonènecessariobloccare
nuovamenteiltelecomandoconla
chiavesenonloritenetenecessario.
ACCENSIONE GENERALE
E GESTIONE DEL
FUNZIONAMENTO
Perpoter gestirel’apparecchio
tramite il telecomando occorre
introdurre la spina di alimentazione
dell’apparecchio
nella presa dell’impianto. Per
trasmettere i comandi occorre
rivolgerela parteanteriore del
telecomandoversolaconsolledel
climatizzatore.
La ricezione del comando emesso
vieneconfermatadall’emissionedi
una nota da parte del cicalino.
Ladistanzamassimaallaqualepuò
avvenire la ricezionedei comandi
corrisponde ad 8 metri circa.
3.3
3.4
REMOVING THE REMOTE
CONTROL
To remove the remote control from
the conditioner, use the special key
provided. Insert the key in the seat
located on the control panel and turn
itanticlockwiseabout90°(g.14).
Grasp the rear part of the remote
control and, turning it slightly, extract
it from its seat. To replace the
remote control in its seat, repeat the
same operation in reverse order. It
is not essential to lock the remote
control with the key again unless
this is deemed necessary.
SWITCHING ON THE
APPLIANCE AND FUNCTION
MANAGEMENT
To manage the appliance using the
remote control, insert the plug on
the appliance to the mains power
supply outlet.
To transmit signals from the remote
control to the appliance, point the
front part of the remote handset
towards the control panel on the air
conditioner.
Receptionofthesignalisconrmed
by a beep.
The maximum signal transmission
distance is about 8 metres.
EXTRACTION DE LA
TÉLÉCOMMANDE
Pourenleverlatélécommandedu
systèmedeclimatisation,ilconvient
d’utiliserla clefprévue à ceteffet
fournie avec l’appareil. Insérer la
clef dans lelogement situésur le
panneau de commande et le tourner
danslesensinversede celui des
aiguillesd’unemontred’environ90°
(g.14).Enleverlatélécommande
de son logementen lasaisissant
par l’arrière et en la faisant
légèrementtournersurelle-même.
Pourremettrelatélécommandeen
placedanssonlogement,effectuer
l’opération inverse. Il n’est pas
nécessairedebloquerànouveaula
télécommandeaveclaclef.
MISE EN MARCHE
GÉNÉRALE ET GESTION DU
FONCTIONNEMENT
Il est nécessaire, pour gérer
l’appareil au moyen de la
télécommande, d’introduire la
fiche d’alimentation de l’appareil
dans la prise de l’installation.
Pourtransmettre les commandes,
diriger la partieantérieure dela
télécommandevers laconsole
duclimatiseur.La réceptionde
lacommande estconfirmée par
l’émissiond’unenotedelapartdu
vibreursonore.
La distance maximale permettant
la réception des commandes
correspondàenviron8mètres.
ENTFERNEN DER
FERNBEDIENUNG
Zur Entfernung der Fernsteuerung
von der Klimaanlage ist der
eigens mitgelieferte Schlüssel
zu verwenden. Stecken Se den
Schlüssel in den Sitz auf der
Bedientafel und drehen ihn um zirka
90° im Gegenuhrzeigersinn (Abb.
14). Ziehen Sie die Fernsteuerung
aus ihrem Sitz, indem Sie diese am
hinteren Teil ergreifen und leicht um
sich selbst drehen lassen. Führen
Sie zur Wiederpositionierung
der Fernbedienung in ihrem Sitz
den Vorgang in umgekehrter
Reihenfolge aus. Es ist nicht
notwendig, die Fernbedienung
erneut mit dem Schlüssel zu
blockieren, wenn Sie dies nicht für
notwendigbenden.
EINSCHALTEN UND
BETRIEBSSTEUERUNG
Um das Gerät über die
Fernbedienung steuern zu
können, muss zunächst der
Gerätenetzstecker in die Steckdose
eingeführt werden.
Zur Übersendung der Befehle
richten Sie die Frontseite der
Fernbedienung auf die Konsole des
Klimagerätes. Ein Summton zeigt
an, dass der Befehl empfangen
wurde.
Der Höchstabstand, bei dem die
Befehle empfangen werden, beträgt
ca. 8 m.
13
14

Related product manuals