EN - 48
ENGLISH
5.3.4 -Anomalies and remedies
Malfunctioning Cause What must be done?
The unit will not start. Current failure Wait for the current to be
restored.
The unit is disconnected
from the current.
Check that the plug is
inserted in the wall socket.
The fuse is interrupted or
the thermal-magnetic circuit
breaker has tripped.
Replace the fuse or restore
the thermal-magnetic circuit
breaker.
The remote control batteries
may be discharged.
Replace the batteries.
The time set with the timer
may not be correct.
Wait or annul the timer
setting.
The appliance doesn’t
cool/heatsufciently
anymore.
Incorrect temperature
setting.
Set the temperature correct
-
ly. Consul the "Using the
remote control" chapter for
the procedure.
The air lter is dirty. Clean the air lter.
The doors or windows are
open.
Close the doors or windows.
The air inlet or outlet vents
of the indoor or outdoor units
are blocked.
First, remove the obstruc
-
tions and then re-start the
unit.
The 3 minutes protection of
the compressor has activated
.
Wait.
The appliance is set to cool
-
ing or heating mode.
Check the active mode from
the remote control display.
The appliance works but
the console (2) is always
off.
The
display has been set
to off.
Reactivate the display from
the remote controller.
The appliance works but
the console buttons (2)
do not work.
The keyboard lock is active. From the signalling console,
disable the keyboard lock.
If the problem has not been solved, please contact the nearest technical as-
sistance service. Please give detailed information about the malfunction and
on the equipment version.
To Next Page
Loading...
