UNICO NEXT R290
EN - 25
ENGLISH
2.5 - ELECTRIC HOOK-UP
The appliance is tted with a power cord with plug
(Y-type connection).
If the socket is in proximity to the appliance, simply
plug it in.
Before connecting the conditioner, ensure that:
• The power supply voltage and frequency values comply with
those indicated on the data plate of the appliance.
• The power supply line is tted with an efcient earth connection
that is appropriately sized for the maximum absorption of the
conditioner (minimum cross-section of the cable must be 1.5
mm2).
• The appliance is powered exclusively through a socket that is
compatible with the plug supplied.
Any replacement of the power cable must be carried out solely by
authorized technical support or by similarly qualied personnel.
On the power supply line of the appliance there must be an adequate
omnipolar disconnection device that complies with the national
installation regulations. It is, however, necessary to check that the
electrical power supply is equipped with efcient earthing and with
adequate protections against overloading and/or short circuits (a
type 10 AT delayed fuse or other devices with equivalent functions
are recommended).
It is possible to proceed with the electric connection through a cable recessed into
the wall in the position indicated in the installation template (connection advised for
installations of the equipment in the top part of the wall).
To prevent any risk of electrocution, it is fundamental to disconnect
the main power switch before carrying out electrical connections
and any maintenance operation on the appliances.
To Next Page
Loading...
