Olimpia splendid Unico Twin - Cleaning the Air Filter; Delivery of the System

50
ENGLISH
2
2.4.1 Cleaning the air lter
OPERATION TO BE PERFORMED WHEN THE MACHINE IS SWITCHED OFF AND THE POWER SUPPLY IS DISCONNECTED.
UNICO MASTER
To ensure effective internal air ltration and satisfactory operation of your air conditioner, the air lter has to be cleaned periodically.
The air lter is at the top of the unit.
Removing the lter:
- manually unhook and turn the front air aspiration grill as indicated in g. 44
- lift the front part of the lter (g. 44 ref. A)
- pull slightly to remove the edge from the upper grid (g. 44 ref. B)
- remove the two supplementary lters (green purifying lter ref. B and black active carbon lter ref. C) from the lter unit (g.
45 ref. A)
- wash and dry all the lters
- t the active carbon lter (black) (g. 45 ref. C) on the lter unit (g. 45 ref. A) and lock it to the specic tongues (g. 45 ref.
D)
- t the purifying lter (green) (g. 45 ref. B) on the rst pin that is on the lter unit (g. 45 ref. E), pull it slightly and lock it on
the other two pins (g. 45 ref. F)
- ret the lter unit by inserting the rear edge (g. 46 ref. B) into the grid (g. 46 ref. A)
- lower the front edge (g. 46 ref. C) on the machine
- reclose and hook the front air aspiration grill
To deactivate LED A (if on), after having powered and started the appliance, press the micro key positioned on the signal console
(g. 24 ref. H) with a pointy object for a brief instant. By doing so, the signal related to the lter cleaning requirement is reset.
WALL SPLIT
The lters behind the air intake grating should be cleaned at least once every three weeks.
- Open the front grating on the inside unit by pulling upward on both sides (g. 47 A)
- Push the two lters gently upward (g. 47 B) so as to free the catch at the bottom, then slide them out downward (g. 47
C).
- Remove the electrostatic lter and catalytic lter from their housing (g. 47 D).
- Clean with a normal vacuum cleaner to remove all the impurities on the lter (g. 48 A).
- To clean the ltering element more thoroughly, it can be washed in lukewarm running water with a mild soapy detergent; rinse
and dry (g. 48 A).
- Replace the electrostatic lter and catalytic lter into their housing.
- Return the two lters to their housing by inserting the upper part rst (g. 48 B), then tting the bottom lter catches in their
housings (g. 48 C).
- Close the grating
2.5 DELIVERY OF THE SYSTEM
Before you leave the site of installation you should gather up all packing material and use a damp cloth to remove any traces of
dust that may have deposited on the machine during assembly (g. 43).
After making all tests and inspections of proper operation of the system, the installer should explain its basic operating features
to the buyer, how to switch it on and off, and normal use of the remote control, as well as practical recommendations for suitable
maintenance and cleaning.