Olimpia splendid Unico Twin - Installation Configurations and Wall Unit Installation; Top;Bottom Installation Options; Unico Wall Installation Guide

ENGLISH
EN - 16
To replace the power cord, proceed as follows:
a. Removethetopandbottominterlockingcovers(g.28).
b. Unscrewthe6screwsthatlockthefrontcover(g.29).
c. Removethefrontcover(g.30).
d. Unscrewthefourxingscrews(X2)(g.31) .
e. Removethefrontcoveroftheswitchgear(X1)(g.31) .
f. Unscrewthecableclamp(J1)(g.32).
g. Unscrew the cables locking screws of the terminal board (J2) .
h. Extract the old cable and insert the new one by following the same path.
i. Lock the three poles of the cable in the terminal board (J2) and tighten the screws.
l. Lock the cable using the strain relief (J1).
m. Close the switchgear .
n. Reassemble the front cover of the machine.
o. Retthetwowedged-incoversupperandlower.
This operation must be performed by specialized personnel possessing the requirements indicated
by law.
2.3.3 - TOP/BOTTOM INSTALLATION CONFIGURATION
Theunitcanbeinstalledbothinthelowerpart(adjacenttotheoor)andintheupperpart(adjacenttothe
ceiling) of the wall.
Dependingoninstallation(ceilingoroor)itissufcienttochangetheelectroniccongurationsoastoopti-
mizetheapertureanglesoftheairoutletap.
AIR OUTLET FLAP CONFIGURATION CHANGE FROM LOW WALL TO HIGH WALL AND VICE VERSA
 Workasfollows(seeg.33-34):
a. Delicatelyopentheapanddetachitfromitssideandcentralhooksonthedeectors.
b. Removethepin(P1)androtatetheap180°.
c. Insertthepin(P1)ontherightsideoftheap.
d. Re-inserttheapbyinsertingthepin(P1)inthelowerholelocatedontherightoftheopening(P2)and
insert the pin already located in the appliance in the lower hole located on the left of the opening.
For correct operating of the appliance, every time that the conguration of the air outlet ap is
modied, there must always be a corresponding respective electronic control setting (see para-
graph 5.6.2).
2.4 - INSTRUCTIONS FOR INSTALLATION UNICO WALL
To obtain the best results and optimum performance, follow the instructions for correct installation provided
in this manual.
A failure to implement the indicated standards, which may cause a malfunction
of the appliances, relieves OLIMPIA SPLENDID from any form of warranty and
from any liability for possible damages caused to people, animals or things.
The electrical system must be compliant with legal standards, must respect
the data in the technical data sheet and be must be equipped with an efcient
ground system.