Olimpia splendid Unico Twin - Ventilation, Heating, Airflow, and Fan Speed; Ventilation Mode Operation; Heating Mode Operation; Adjusting Airflow Direction

U10
U9 UY
U8 UX
ENGLISH
EN - 28
If both units are in operation, UNICO MASTER and WAL ventilation is limited to low speed.
5.4.9 - NIGHT WELL-BEING KEY
Press the T3button(nightwell-being)toobtainseveralresults,specically:
• Gradualincreaseofthesetcoolingtemperature.
• Gradualdecreaseofthetemperaturesetforheating(onlyHPmodels).
5.5 - Timer setting
• TheappliancelogicallowstheUsertomakeuseoftwodifferenttimerprograms(seeparagraph5.5.2),
thanks to which the appliance can be deactivated and activated (or vice versa) whenever desired (for
example,itcanbeactivatedshortlybeforereturninghomesoastondanalreadypleasanttemperature
in the room).
• Firstly,ifitisdesiredtomakeuseofthesefunctions,setthecorrecttime(seeparagraph5.5.1)andthen
set the timer as you prefer.
5.5.1 - SETTING THE CORRECT TIME
Work with the remote control as follows in order to set time:
a. Press key T6 until when the indication of the hours h
(U10) appears on the display.
b. Increase or decrease the hours indication by means of
the tilt selector T7.
c. Press key T6 until when the indication of the minutes m
(U10) appears on the display.
d. Increase or decrease the minutes indication by means
of the tilt selector T7.
e. Press key T6 to save the set time.
5.5.2 - TIMER SETTING
(PROGR. 1 AND PROGR. 2)
It is possible to set one or both the timer programs.
To set the appliance activation and deactivation times in the
two programs, use the remote control and work as follows:
a. Press key T6 once or more until when the symbol 1 (U8)
appears on the display (Switch-on time of the 1° program).
b. Increase or decrease the time at which you desire the
air conditioner activates by means of the tilt selector T7.
The variation of the settable time with selector T7 is of
30 minutes.
c. Press key T6 a second time; the symbol 1 (U8-UX) appears
on the display (Switch-off time of the 1° program).